SINKER STOP TOOL KIT

The Mojo Slip Shot Sinker Stop Tool has been modified and upgraded to a heavier duty stainless steel wire, which makes it very durable and gives the tool memory.

This allows it to conform to its original shaped design after each usage. When sliding the sinker on the line, other after market pegging systems fray and damage the line. Mojo has heard this complaint over and over from avid anglers whom have used the "other guys" rubber pegs. Saying, "You might as well crush the sinker or use a toothpick to peg the sinker to the line. You would honestly probably get better results.

But thanks to the innovative team at Mojo, the Sinker Stop Tool kit was designed to do the job dependably and professionally. After all, Mojo created this system for its Slip Shot Sinker System also referred to as the Mojo rigging method. Who would know better?

Designed to insert rubber strands into the slip shot sinker, pegging the weight, not crimping the weight on. This method also allows the sinker to be moved up and down the line with resistance to adjust leader length. No more damaging or retying your leader line to the desired length, as you would with a Carolina Rig. The Mojo Sinker Stop tool kit (with individual strands of rubber) cause no fraying or damage to your line, simply because of its design for use.

When you install 2 individual strips of pegging rubber into the tool and pull them through the weight bore, you are now actually doubling that number to four. The rubber strands wrap themselves around your fishing line and allow even pressure and complete cushioning of your line from abrasion of the weight, while sliding the weight on your line. Other pegging methods available include single rubber round stock pegs that you stick into the sinker bore to peg or anchor the sinker to your line. This may be simple and convenient; however, these single strand rubber cores permit all of the pressure to be exerted to only one side of the fishing line with absolutely no protection or cushioning effect, causing the line to be forced and crushed against the weight bore.

The tool can also be used to peg a 8mm bead to the line as a sinker stop, thus eliminating the use of a swivel and pre-tied leader line. The bead can now be adjusted to give you preferred leader length without a hassle. You can use two glass beads with this method for more clattering noise and pegging one of them. If you go to adjust the bead and it won’t move, simply wet the bead and line with lubricant from your mouth and now it will slide. WaaLa!

The Mojo tool can also be used to thread line through hook eyes. It works especially well on braided lines such as fire line and spider wire. These spectra lines tend to fray at the end and make it nearly impossible at times to insert your line through the hook eyelet. Each kit comes with 3 pieces of new larger diameter rubber, each piece supplies 22 individual strands of rubber, and new improved tool along with rigging instructions. Now 2 individual strands of rubber will peg any weight in place making it simpler than ever, where before it took 4 to 5 strands.

Get yours today!